Blame | Last modification | View Log | RSS feed
/*** Marlin 3D Printer Firmware* Copyright (C) 2016 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]** Based on Sprinter and grbl.* Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm** This program is free software: you can redistribute it and/or modify* it under the terms of the GNU General Public License as published by* the Free Software Foundation, either version 3 of the License, or* (at your option) any later version.** This program is distributed in the hope that it will be useful,* but WITHOUT ANY WARRANTY; without even the implied warranty of* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the* GNU General Public License for more details.** You should have received a copy of the GNU General Public License* along with this program. If not, see <http://www.gnu.org/licenses/>.**//*** Cheaptronic v1.0 pin assignments*/#ifndef __AVR_ATmega2560__#error "Oops! Make sure you have 'Arduino Mega' selected from the 'Tools -> Boards' menu."#endif#define BOARD_NAME "Cheaptronic v1.0"//// Limit Switches//#define X_STOP_PIN 3#define Y_STOP_PIN 2#define Z_STOP_PIN 5//// Steppers//#define X_STEP_PIN 14#define X_DIR_PIN 15#define X_ENABLE_PIN 24#define Y_STEP_PIN 35#define Y_DIR_PIN 36#define Y_ENABLE_PIN 31#define Z_STEP_PIN 40#define Z_DIR_PIN 41#define Z_ENABLE_PIN 37#define E0_STEP_PIN 26#define E0_DIR_PIN 28#define E0_ENABLE_PIN 25#define E1_STEP_PIN 33#define E1_DIR_PIN 34#define E1_ENABLE_PIN 30//// Temperature sensors//#define TEMP_0_PIN 15 // Analog Input#define TEMP_1_PIN 14 // Analog Input#define TEMP_BED_PIN 13 // Analog Input//// Heaters / Fans//#define HEATER_0_PIN 19 // EXTRUDER 1#define HEATER_1_PIN 23 // EXTRUDER 2#define HEATER_BED_PIN 22//// LCD / Controller//// Cheaptronic v1.0 doesn't support LCD#define LCD_PINS_RS -1#define LCD_PINS_ENABLE -1// Cheaptronic v1.0 doesn't support keypad#define BTN_EN1 -1#define BTN_EN2 -1#define BTN_ENC -1