Blame | Last modification | View Log | RSS feed
/*** Marlin 3D Printer Firmware* Copyright (C) 2016 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]** Based on Sprinter and grbl.* Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm** This program is free software: you can redistribute it and/or modify* it under the terms of the GNU General Public License as published by* the Free Software Foundation, either version 3 of the License, or* (at your option) any later version.** This program is distributed in the hope that it will be useful,* but WITHOUT ANY WARRANTY; without even the implied warranty of* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the* GNU General Public License for more details.** You should have received a copy of the GNU General Public License* along with this program. If not, see <http://www.gnu.org/licenses/>.**//*** Gen6 pin assignments*//*** Rev B 26 DEC 2016** 1) added pointer to a current Arduino IDE extension* 2) added support for M3, M4 & M5 spindle control commands* 3) added case light pin definition**//*** A useable Arduino IDE extension (board manager) can be found at* https://github.com/Lauszus/Sanguino** This extension has been tested on Arduino 1.6.12 & 1.8.0** Here's the JSON path:* https://raw.githubusercontent.com/Lauszus/Sanguino/master/package_lauszus_sanguino_index.json** When installing select 1.0.2** Installation instructions can be found at https://learn.sparkfun.com/pages/CustomBoardsArduino* Just use the above JSON URL instead of Sparkfun's JSON.** Once installed select the Sanguino board and then select the CPU.**/#if !defined(__AVR_ATmega644P__) && !defined(__AVR_ATmega1284P__)#error "Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu."#endif#ifndef BOARD_NAME#define BOARD_NAME "Gen6"#endif//// Limit Switches//#define X_STOP_PIN 20#define Y_STOP_PIN 25#define Z_STOP_PIN 30//// Steppers//#define X_STEP_PIN 15#define X_DIR_PIN 18#define X_ENABLE_PIN 19#define Y_STEP_PIN 23#define Y_DIR_PIN 22#define Y_ENABLE_PIN 24#define Z_STEP_PIN 27#define Z_DIR_PIN 28#define Z_ENABLE_PIN 29#define E0_STEP_PIN 4 // Edited @ EJE Electronics 20100715#define E0_DIR_PIN 2 // Edited @ EJE Electronics 20100715#define E0_ENABLE_PIN 3 // Added @ EJE Electronics 20100715//// Temperature Sensor//#define TEMP_0_PIN 5 // Analog Input//// Heaters//#define HEATER_0_PIN 14 // changed @ rkoeppl 20110410#if !MB(GEN6)#define HEATER_BED_PIN 1 // changed @ rkoeppl 20110410#define TEMP_BED_PIN 0 // Analog Input#endif//// Misc. Functions//#define SDSS 17#define DEBUG_PIN 0#define CASE_LIGHT_PIN 16 // MUST BE HARDWARE PWM// RS485 pins#define TX_ENABLE_PIN 12#define RX_ENABLE_PIN 13//// M3/M4/M5 - Spindle/Laser Control//#define SPINDLE_LASER_ENABLE_PIN 5 // Pin should have a pullup/pulldown!#define SPINDLE_LASER_PWM_PIN 16 // MUST BE HARDWARE PWM#define SPINDLE_DIR_PIN 6